LED Ring connections - V1

Hello Guys!

In this article you will learn how to properly connect your LED Ring to the Arduino Controller:

1. On the Arduino board (the black little box), if the port is at the bottom - the cables should be connected as follows:

a. On the left side of the board - the top two pins Are VIN and GND.

b. On the right side of the board - the 8th pin from either side (Please see photo for reference).

2. Connect your Arduino to the Ring (V1-V2):

a. Please Attach a cable from 5v on the board to DI on the Ring.

b. Attach a cable from VIN on the Board to 5v on the Ring.

c. Attach a cable from the GND Port on the Board to the GND on the Ring.

Click here to see how to connect the Arduino controller to the LED Ring with mini USB cord.